Cylinder Assembly

1. Place first hub on shaft and lock with set screws at preselected location from one end of shaft.
2. Slide remaining hubs on shaft, while still loose, space approximately 8" apart.
3. Insert two (2) preformed strips into clamps on all hubs, make certain wedge devices rest above and between strips. Only fasten strips at first hub (end of strip flush with face of hub) which is already secured to shaft.
4. Allow spiral in strips to set brush helix. Move last loose hub to opposite end of the temporarily installed two strips - keep ends flush with face of hub - tighten strips into clamp. Check brush length and adjust hub laterally as needed. Lock hub in place with set screws.
5. Equally space remaining center flanges and secure with set screws. Tighten (2) strips into clamps.
6. Install balance of strips in groups of (2), into clamps and lock at each flange location.
7. Recheck all clamping screws and hub set screws for tightness.

Since hubs become permanent fixtures of your shaft, replacement of worn strips with new refills is a simple operation - but for BEST and FAST results, remove and assemble in groups of (2) strips for every clamp around perimeter of hub.

CAUTION: Spacing between hubs should never exceed 9" from face to face of adjacent hub.

Thread locking adhesive can be used to hold screws more securely if your application requires it.