Coil on Core & Shaft

Design Your Brush

Coil on Core & Shaft

coilshaft-01When Fuller Custom Brush originated the Fullergript® design, a revolutionary brush making process was created.


The Fullergript® process provides an economical means of incorporating brush technology into a wide range of modern commercial applications.


By winding Brush Strip on a mandrel or shaft, a coil brush is produced. Brush density can be varied by your choice of backing size.


The amount of fill material increases proportionately with the size of the backing.



The lead of the coil (distance between wraps), affects the working surface of the brush and its performances.


Consistent or continuous brush to work surface contact requires a close wound coil (no lead), while an open lead is recommended when working with aggregate, grain or debris.


  Click for more information on Coil Brush
 

Complete request for quote design form below


Dimensions

coilbrush-02

inches
inches
inches

 Closed

Open - dimension from center
of one coil to the center of the
next successive coil.

inches


Fill Material
inches


Backing Material


Core Dimensions

coilcore-02

inches inches inches


Core Material
inches


Brush Positioning on Core


Shaft Material


Full Shaft Dimensions

coilshaft-02

inches inches inches


Stub Shaft Dimensions

coilshaft-03

inches inches inches


Operating RPM


Bristle Penetration intormation


Quantity


Brush Application or Additional Comments

Upload Drawing

   Select File:

Customer Information

*Please fill out all areas of the form below before submitting.